To distribute power in my homemade solar generator, I used a 6-circuit fuse panel for the positives, and for the grounds, I used a busbar. Fix both of these to the case floor using a hot glue gun. Once the glue dries, I recommend you add another layer of superglue all around the edges. Do the same for the positive inline fuse. .
To wire the LED light, you need to shorten the cable just enough to reach the switch. Strip the outer insulation on the end, as well as the insulation of the (+) and (-) wires that are inside. Since the switch also has an indicator light, it. .
Take the leads from the 18V socket and connect the charge controller. Now go ahead and connect the charge controller to the fuse box and negative bus bar. Since I used a solar.
[pdf] found, see solution. wire. Re-test with wireless controller. If found to work at this .
Power-Pole anchor does not hold anchor position/will not remain retracted. .
Ensure the system is fully primed for proper performance and operation of the unit. .
Improper installation of the hydraulic tubing/hose may cause the tubing/hose to become kinked during anchor deployment. .
Over tightening of the fasteners may cause the unit to become Replace any bent or damaged components.
[pdf] 
