What is a roof mounted photovoltaic system guidance?

The guidance refers only to the mechanical installation of roof mounted integrated and stand-off photovoltaic systems; it provides best practice guidance on installation requirements and does not constitute fixing instructions.

How do I mount a PV module to a substructure?

MOUNTING INSTRUCTIONS PV modules can be mounted to the substructure using either corrosion-proof M8 bolts placed through the mounting holes on the rear of the module or specially designed module clamps. A clearance of at least 115mm(4.5in) (recommended) is provided between modules frame and the surface of the wall or roof.

Can a racking system be used to ground a PV module?

This racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with the included instructions. The system is a non-separately derived system.

How to ground a SUNTECH PV module?

The material and size of the ground cable should meet the requirements of the local national, regional or international regulations, laws and standards. 4 to 14 mm2 (AWG6-12) exposed copper cable is recommended. Suntech PV modules can be grounded using a third-party grounding device, but the grounding must be proven reliable.

How to install a photovoltaic light fixture?

The fixture shall be installed within the scope authorized by Suntech. The inside side of the fixture and the side of the photovoltaic module should be completely fitted. In any fixture installation mode, the fixture must not touch the glass or deform the frame of the bracket or module.

How should a PV system be designed & installed?

From the outset, the designer and installer of a PV system must consider the potential hazards carefully, and systematically devise methods to minimise the risks. This will include both mitigating potential hazards present during and after the installation phase.